Vent-free Fireplace System Installation and Operating Instruction

23D8036 7
GETTING STARTED
MAKE SURE YOU HAVE RECEIVED ALL PARTS
Check your packing list to verify that all listed parts have been received. You should have the following:
Installation/Operating instructions Black Louvers (5)
33" unvented gas heater with brick panels. Canopy
Volcanic rock and rock wool Two (2) anchoring screws
Mounting screws for canopy
Log box (refer to installation instructions)
Accessory face plates available to finish the insert.
DIFACESM Black small face 33"H x 43"W DIFACELG Black large face 36"H x 50"W
Accessories include brass trim and mounting hardware
The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF
functions. The following options may be used with the milli-volt controlled heater. These options are not packaged with the
log set.
Hand held Remote with Receiver Wall switch with 15' wire. Wall T-stat with 15' wire.
Hand held Thermostat Remote with Receiver Thermostat Sensor
Handle the gas log burner assembly by the grate only. Do not pick the unit up
by the burners.
Gloves are recommended when handling ceramic ber logs to prevent skin irritation
from loose bers. Logs are fragile — handle with care.
WARNING
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts
in good condition.
WHAT YOU WILL NEED FOR INSTALLATION
You must have the following items available before proceeding with installation…
External regulator (for propane / L.P.G. and 1/2 lb. Natural Gas Systems only)
Piping which complies with local codes Sediment trap
Tee joint Pipe wrench or appropriate size crescent wrench set
Phillips head screwdriver Drill with 5/32" bit
Optional face plate kit. Manual shutoff valve
Optional trim kit for installation into wall or free standing Mantle without three piece faceplate
Pipe sealant approved for use with propane / LP.G (Resistant to sulfur compounds)