Owner's Manual

11
STEP 19: SECURING THE DRIVER ASSEMBLY
19a After removing the handles and baffle protector, secure
the remaining (27 total) included machine screws.
19b To establish the speaker wire connection with the back
box, carefully tighten the included brass contact screws
with a Phillips screw driver. There are a total of (4)
brass contact screws that need to be installed. 2 on
top, and 2 on bottom. These screw holes are located
directly above the top bass driver and directly below
the bottom bass driver.
NOTE: The speaker will not play if these screws are not
installed.
19c The binding posts located on the front of the Driver
Assembly should only be used for temporary/
troubleshooting purposes and are not intended to be
used during normal operation and can otherwise be
ignored.