Owner's Manual

STEP 18: MOUNTING THE DRIVER ASSEMBLY

THIS STEP REQUIRES 2 PEOPLE TO COMPLETE SAFELY

18a With 2 people, lift the driver assembly from its

packaging using the attached handles.

18b With 2 people, carefully seat the driver assembly into

the back box by guiding the driver assembly alignment

pins into the mating holes on the back box. Be careful

not to damage the wall surface during this step.

18c While 1 person continues to hold the driver assembly

securely in place, the other should install the included

8-32 screws through the driver assembly into the back

box. These specific locations are marked as “through”

holes in the attached plastic baffle protector. (3/32 hex

driver bit required for machine screws. Not included)

18d Once all 8-32 screws have been tightened, the driver

assembly is now securely attached to the back box.

The person holding the driver assembly in place can

now let go.

18e You may now safely remove the handles and plastic

baffle protector from the driver assembly. (Handle

removal will require the 5/32 hex driver bit. Not

included.)

NOTE: Left channel orientation shown here. Right channel

will be mirrored.

x 4 x 4