Manual

5) Tighten the jam nut snugly by hand. Do not

over tighten the nut.

6) Right the speaker. Caution: Make sure your

hands and any cabling are clear of the spikes.

Do not slide speaker as spikes are sharp and

can damage your floor or carpet.

7) Adjust to level by rotating spikes. Tighten the

jam nut securely when satisfied that speaker

is level. Caution: “Walking” the speaker may

result in a broken spike.

INSTALLING ON A FLAT SURFACE

(MOTION 50XTi/35XTi/30i/15i)

If you have a surface that provides a wide, level,

and stable platform, the speaker can be placed

directly on top. When using the speaker in this

configuration, affix the pads to the bottom of the

speaker at the rear contact points (fig. 8). Note:

This speaker is not magnetically shielded and

therefore should not be placed directly beside or

atop a CRT television.

VERTICAL DISPERSION (MOTION 50XTi/30i)

For optimal performance, the Folded Motion

tweeter should be aimed in the direction of your

ears when sitting in your primary listening position.

If your speaker is installed near or slightly below

ear height, orient the speaker so the flat side is on

bottom. When this speaker is installed on a low

surface, orient the speaker so the angled side is on

bottom (see figure 9).

INSTALLING ON A STAND OR WALL

BRACKET (MOTION 50i/35XTi/30i/15i)

When using aftermarket floor stands or wall brack-

ets, choose one with a shelf-like platform upon

which the speaker rests and which is designed to

support the weight of your speaker. WARNING!

The 3/8 - 16 threaded insert on the back of the

Motion 15i is not intended to bear the full weight

of the speaker in a free-hanging installation. It is

designed only to secure the speaker to stands and

brackets that offer support from beneath.

Fig. 8

Fig. 9