User manual

19
When you select a new sequence, or group of
sequences, your selection blinks in the display,
indicating that it is not yet executing. To start executing
the selection press (QWHU. Whatever you have selected
will run in a continuous loop.
TRIG RATES
Triggers are used to activate scene changes. The higher
the trig rate then the faster the scenes change. There are
a range of trigger options available with the MC-
Showtime controller that are explained in this section.
Note that if no trig mode is active then the fixtures will
not change to the next scene at the end of executing the
current scene. They will wait for a trigger signal.
All sequences with medium movement and action.
Each of the ten medium sequences is played 12
times. Execution starts at sequence 1, runs through to
sequence 10 (shown as 0), and then starts again.
All sequences with fast movement and action. Each
of the ten fast sequences is played 12 times.
Execution starts at sequence 1, runs through to
sequence 10 (shown as 0), and then starts again.
Sequence
Fast
Medium
Slow
Auto
Trig
Music
Trig
Sequence
Fast
Medium
Slow
Auto
Trig
Music
Trig