User Manual

8 RUSH MH 3 Beam User Manual
Block access below the work area and work from a stable
platform whenever installing, servicing or moving the fixture.
Do not operate the fixture with missing or damaged covers,
shields or any optical component.
Do not lift or carry the fixture by its head. Support the fixture by
its base only.
In the event of an operating problem, stop using the fixture
immediately and disconnect it from power. Never attempt to
use a fixture that is obviously damaged.
Do not modify the fixture in any way not described in this
manual or install other than genuine RUSH by Martin™ parts.
Refer any service operation not described in this manual to a
qualified technician.
Lamp safety
Install only a lamp that is approved by Martin™ for use in the
product.
Prolonged exposure to an unshielded discharge lamp can
cause eye and skin burns. Do not look at an exposed lamp
while it is lit. Do not operate the fixture with missing or
damaged covers, shields, lenses, ultraviolet screens or any
optical component.
A hot discharge lamp is under pressure and can explode
without warning. Allow the fixture to cool for at least 2 hours
and protect yourself with safety glasses and gloves before
handling a lamp.
Replace the lamp immediately if it becomes visually deformed,
damaged or in any way defective.
Monitor hours of lamp use. Replace the lamp when it reaches
the limit of its service life as specified in this manual or by the
lamp manufacturer. If you exceed the lamp lifetime, the lamp
may explode and damage the fixture.
If the quartz envelope of a discharge lamp is broken, the lamp
releases a small quantity of mercury and other toxic gases. If a
discharge lamp explodes in a confined area, evacuate the area
and ventilate it thoroughly. Wear nitrite gloves when handling a
broken discharge lamp. Treat broken or used discharge lamps
as hazardous waste and send to a specialist for disposal.