User Manual

22 RUSH MH 3 Beam User Manual
Ignition delay
An ignition delay of 0 to 255 seconds can be set so that there is a delay
between power on and lamp on. This can help you avoid electrical problems if
a large number of lamps power on at the same time. To set a delay:
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select IGNITION DELAY and press
ENTER to confirm.
3. Use the DOWN and UP buttons to scroll to a duration.
4. Press ENTER to confirm that duration (or press MENU to exit without
making a change).
Low power delay
To set a low power delay, where the lamp runs at half power for a period
before shutting off when a lamp off command is issued:
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select LOW POWER DELAY and press
ENTER to confirm.
3. Use the DOWN and UP buttons to specify a duration.
4. Press ENTER to confirm (or press MENU to exit without making a
change).
Display settings
Invert display
Inverting the display is useful if the fixture is hung from a truss or from
elevation. To invert the display:
1. Select DISPLAY SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select DISPLAY INVERSE and press
ENTER to confirm.
3. Use the DOWN and UP buttons to select YES (inverted) or NO (normal).
4. Press ENTER to confirm (or press MENU to exit without making a
change).