User Manual

RUSH MH 3 Beam User Manual 19
Behavior when DMX signal is not present
You can set the fixture so that when it is powered on but not receiving a DMX
signal, it either continues to display the last effect it was displaying when it
was receiving a DMX signal or blacks out.
To set fixture behavior when it is not receiving DMX:
1. Select DMX FUNCTIONS and press ENTER.
2. Use the UP and DOWN buttons to select DMX STATE and press ENTER.
3. Use the UP and DOWN buttons to select either HOLD (fixture displays
last effect it was displaying when receiving DMX) or BLACKOUT (fixture
blacks out) and press ENTER. The default setting is BLACKOUT.
4. Press MENU to exit.
DMX viewer
You can check the DMX values that the fixture is receiving on each DMX
channel in the VIEW DMX VALUE menu.
To see the DMX values:
1. Select DMX FUNCTIONS and press ENTER.
2. Use the UP and DOWN buttons to select VIEW DMX VALUE and press
ENTER.
3. Use the UP and DOWN buttons to scroll through the DMX channels and
press ENTER to select a channel. The fixture will display the DMX value it
is receiving on that channel.
4. Press MENU to exit the viewer.
Fixture settings
Pan and/or tilt inversion
The FIXTURE SETTINGSPAN INVERSE and TILT INVERSE menus can be
used to reverse the direction of pan and/or tilt. These settings are useful for
symmetrical effects with multiple fixtures, or when coordinating the movement
of fixtures that are floor mounted and rigged upside down.
To adjust the pan inversion settings:
1. Select FIXTURE SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select PAN INVERSE or TILT
INVERSE and press ENTER to confirm.