User manual

4 Martin MAC Viper Quadray™ Module Installation and DMX Control Guide
9. See Figure 6. Gather up
a loop in the Quadray
Module wireset and
push it into the space A
between the module and
the head air filter. Push
the wireset’s
multiconnector onto the
corresponding socket B
in the head.
10. See Figure 7. Fasten the multiconnector to the
socket with the multiconnector’s two screws
(arrowed).
11. Reinstall the head cover, checking that its safety
wire is securely attached before tightening its
retaining screws.
12. Release the tilt lock, then apply power. With
MAC Viper AirFX firmware version 1.2.0 or later
installed, the fixture will recognize that the
Quadray Module is installed.
13. In the control panel, scroll through the
CALIBRATION menu until you reach Ray1. Enter
the calibration value for L1 that is printed on the
module connector. Scroll to Ray2 - Ray4 and
enter the calibration values for L2 - L4.
14. Check and if necessary adjust the lamp
alignment as described in the MAC Viper AirFX
user manual. Remove any significant hotspot in
the rays.
When the Quadray Module is installed and the fixture is
powered on, the MAC Viper AirFX recognizes the new
module automatically and configures itself for operation with
the module.
If you remove the Quadray Module and reinstall the standard
components, the fixture will recognize that no module is
present and reconfigure itself for operation without the
module.
The calibration values printed on the module connector must
follow the module. If you install the Quadray Module on
another fixture, remember to enter the module’s calibration
values in the new fixture’s control panel.
Remember also to check lamp alignment each time you
install the module.
Figure 6
A
B
Figure 7