User manual

Martin MAC Viper Quadray™ Quadray Installation and DMX Control Guide 3

5. See Figure 3. Line up the Quadray

Module over the head so that the

module’s safety wire will pass through

the cutout in the front of the head above

the safety wire attachment point A and

the module’s wireset will pass through

the cutout B in the opposite side of the

head.

6. Lower the Quadray Module onto the

head, making sure that it sits completely

square to the head. Do not use

excessive force. You may need to rotate

the module slightly to the left and to the

right until you can feel that it has

engaged correctly. Check also that the

safety wire and wireset are not trapped

between the module and the head.

7. See Figure 4. Fasten the module in place by tightening the four

screws on the front of the module.

8. See Figure 5. Pass the Quadray Module’s safety

cable through the hole A in the head chassis and

then into the safety wire attachment point B. Push

and slide the fastener so that it is locked into the

attachment point.

Figure 3

Figure 4

Figure 5