User guide

28 MAC Viper AirFX User Guide
PERSONALITY
(continued)
EFFECT
SHORTCUT
ON
Effects take shortest route during
changes, crossing open positions if
necessary
OFF
Effects avoid open positions during effects
changes
DISPLAY SLEEP
ON Display permanently on
2 MINUTES
Display goes into sleep mode 2 minutes
after last key press
5 MINUTES
Display goes into sleep mode 5 minutes
after last key press
10 MINUTES
Display goes into sleep mode 10 minutes
after last key press
DISPLAY
INTENSITY
10 ... 100 Set display intensity in % (default = 100)
DISPLAY
ROTATION
NORMAL / ROTATE 180 Display orientation normal or rotated 180°
DISPLAY
CONTRAST
1 ...100 Adjust contrast of display (default = 90)
ERROR MODE
NORMAL
Enable error messages and warnings in
display
SILENT
Disable error messages and warnings in
display (the status LED will still light to
indicate fixture status if an error has been
detected or the fixture has a warning)
FACTORY
DEFAULT*
LOAD FACTORY
SETTINGS
ARE YOU SURE?
YES/NO
Return all settings (except calibrations) to
factory defaults
INFORMATION*
POWER ON TIME
TOTAL 0 ... XXX HR
Display hours fixture has been powered on
since manufacture (not user-resettable)
RESETTABLE
CLEAR
COUNTER?
YES/NO
Display hours fixture has been powered on
since last counter reset (user-resettable)
LAMP ON TIME
TOTAL 0 ... XXX HR
Display hours of lamp use since
manufacture
(not user-resettable)
RESETTABLE
CLEAR
COUNTER?
YES/NO
Display hours of lamp use since last
counter reset (user-resettable)
LAMP STRIKES
TOTAL 0 ... XXX HR
Display number of times lamp has been
struck since manufacture (not
user-resettable)
RESETTABLE
CLEAR
COUNTER?
YES/NO
Display number of times lamp has been
struck since last counter reset
(user-resettable)
SW VERSION XX.XX.XX Displays currently active software version
SERIAL NUMBER (XX)XXXXXXXXXXXX Displays fixture’s serial number
RDM UID 4D50.XXXXXXXX Displays fixture’s unique RDM ID
FAN SPEEDS
LAMPFAN L ...
BASEFAN 4
0 - XXX RPM
Displays current speed of all cooling fans
(lamp, head and base)
TEMPERA-
TURES
ZOOM/FOCUS ...
POWER
X C
Displays temperature in °C of all PCBs and
of internal PSU
DMX LIVE*
RATE 0 - 44 HZ
DMX transmission speed in packets per
second
QUALITY 0 - 100% Percent of packets received
START CODE 0 - 255 Value of the DMX start code
STROBE/SHUTTER ... FX SYNC
Value received on each DMX channel
(values for fine control channels can only
be viewed if available in the DMX mode
the fixture is set to)
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 4: Control menus