User manual

Service and display messages 61
FAN LAMP L FAN ERROR
FAN BOTTOM FAN ERROR
FAN CMY FAN ERROR
FAN TOP FAN ERROR
FAN MAINBOARD FAN 1ERROR
FAN POWER FAN 1 ERROR
FAN POWER FAN 2 ERROR
FBEP PAN FEEDBACK ERROR
Unable to correct pan position
FBET TILT FEEDBACK ERROR
Unable to correct tilt position
FOER FOCUS ERROR
FRER FRAMING ROTATION ERROR
FSER FRAMING SHUTTER 1 INS ERROR
FSER FRAMING SHUTTER 1 ANG ERROR
FSER FRAMING SHUTTER 2 INS ERROR
FSER FRAMING SHUTTER 2 ANG ERROR
FSER FRAMING SHUTTER 3 INS ERROR
FSER FRAMING SHUTTER 3 ANG ERROR
FSER FRAMING SHUTTER 4 INS ERROR
FSER FRAMING SHUTTER 4 ANG ERROR
FUSB FORCED USB UPLOAD ENABLED
The fixture has been started in forced upload mode (the Escape button was held during power up).
G11M GOBO WHEEL GOBO 1 MISSING
The gobo is not installed, faulty, or operating in extremely cold temperatures. Instal, replace or allow
the gobo to warm up.
G12M GOBO WHEEL GOBO 2 MISSING
The gobo is not installed, faulty, or operating in extremely cold temperatures. Instal, replace or allow
the gobo to warm up.
G13M GOBO WHEEL GOBO 3 MISSING
The gobo is not installed, faulty, or operating in extremely cold temperatures. Instal, replace or allow
the gobo to warm up.
G14M GOBO WHEEL GOBO 4 MISSING
The gobo is not installed, faulty, or operating in extremely cold temperatures. Instal, replace or allow
the gobo to warm up.
G15M GOBO WHEEL GOBO 5 MISSING
The gobo is not installed, faulty, or operating in extremely cold temperatures. Instal, replace or allow
the gobo to warm up.
G1ER GOBO WHEEL ERROR
GELF GENERATE EVENT LOG FAILED
GOER GOBO WHEEL ERROR
The sensors, wiring and motor need to be checked and the driver PCB may need to be replaced.
HOT LAMP TOO HOT TO RESTRIKE
The fixture will attempt to restrike at 20 second intervals. After 90 seconds if the lamp still refuses to
strike, LERR is displayed
HT W HEAD TEMPERATURE TOO HIGH
One or more of the PCB's in the head is above 85 degrees celsius. Power off the fixture, allow it to
cool, and restart.
HTCO HEAD TEMP CUT OFF
One or more of the PCB's in the head is above 95 degrees celsius. Power off the fixture, allow it to
cool, and restart.
HTER HEAD TEMP HIGH
The temperature on a PCB in the head is high. A fan might be defective or the ambient temperature
may be too high.
IRER IRIS ERROR
LAER LAMP ERROR
The lamp is defective or has exploded, is missing, or the lamp cannot restrike after 90 seconds.
Short code Full-text message
Table 6: Error messages