User manual

60 MAC III Performance user manual
CDPT CALIBRATE DATA PAN/TILT
Unable to read/write data to external eeprom board (Calibrate Data) on Yoke. The PCB needs to be
replaced.
CDZF CALIBRATE DATA ZOOM/FOCUS
Unable to read/write data to external eeprom board (Calibrate Data) on Zoom/Focus module. The
cables need to be checked or the module may need to be replaced.
CECH COM ERROR CHARGER
I2C communication between main controller and charger failed. The cables need to be checked or
the module may need to be replaced.
CECM COM ERROR CMY
CAN communication between main controller and CMY driver failed. The cables need to be
checked or the driver may need to be replaced.
CECO COM ERROR COOLING
CAN communication between main controller and cooling driver failed. The cables need to be
checked or the driver may need to be replaced.
CEEF COM ERROR EFFECT
CAN communication between main controller and effects driver failed. The cables need to be
checked or the driver may need to be replaced.
CELF CLEAN EVENT LOG FAILED
CEPT COM ERROR PAN/TILT
CAN communication between main controller and pan/tilt driver failed. The cables need to be
checked or the driver may need to be replaced.
CEPU COM ERROR POWER UNIT
I2C communication between main controller and ballast failed. The cables need to be checked or
the module may need to be replaced.
CEUI COM ERROR UI
User interface communication failure. The cables need to be checked or the module may need to be
replaced.
CEZF COM ERROR ZOOM/FOCUS
CAN communication between main controller and zoom/focus driver failed. The cables need to be
checked or the driver may need to be replaced.
COLD FIXTURE IS COLD
PCBs are below -20° C (-4° F)
CONC COOLING NO CONNECTION
(s/w versions prior to ver. 1.3)
CONE EFFECT NO CONNECTION
(s/w versions prior to ver. 1.3)
CONM CMY NO CONNECTION
(s/w versions prior to ver. 1.3)
CONP PAN/TILT NO CONNECTION
(s/w versions prior to ver. 1.3)
CONZ ZOOM/FOCUS NO CONNECTION
(s/w versions prior to ver. 1.3)
CTER CTC ERROR
The sensors, wiring and motor need to be checked and the driver PCB may need to be replaced.
CYER CYAN ERROR
The sensors, wiring and motor need to be checked and the driver PCB may need to be replaced.
DIER DIMMER ERROR
The sensors, wiring and motor need to be checked and the driver PCB may need to be replaced.
DINA DIMMER NOT ADJUSTED
Dimmers need to be adjusted by a qualified service technician.
ECDE EFFECT CALIBRATE DATA PCB
(s/w versions prior to ver. 1.3)
Unable to read/write data to external EEPROM board (calibrate date) on effect module
EEDF WRITING EEPROM DEFAULT(S)
No valid EEPROM in a CAN module. Writing default into the EEPROM based on the CAN address.
Module is possibly incorrectly connected
EEPR EEPROM INVALID/NO CONN.
No connection or EEPROM data invalid
EFSM ERROR FAILSAFE MODE
Module error detected during self-check at startup. Service intervention required. Fixture control
possibly disabled, depending on nature of error.
FAN LAMP R FAN ERROR
Short code Full-text message
Table 6: Error messages