User manual

58 MAC III Performance user manual
FIXTURE
INFORMATION
(continued)
FAN SPEED Displays speed in RPM of all cooling fans
TEMPERATURE
Displays temperature in °C of all PCBs and
of ballast capacitor
POWER UNIT
Displays voltage at mains power input,
voltage, current and wattage at lamp
terminals, lamp status, igniter status and
lamp intensity.
EVENT LOG VIEWER Views fixture event log
DMX LIVE
RATE
DMX transmission speed in packets per
second
QUALITY Percent of packets received
START CODE Value of the DMX start code
STROBE/SHUTTER → FIXTURE ADJUSTMENTS
DMX value (0 - 255) received on each
channel
Values for fine control channels can only
be viewed if available in the DMX mode
the fixture is set to
TEST SEQUENCE
ACTION Start / Stop / Pause Run test sequence of all functions
REPEAT On / Off Enable auto-repeat of test sequence
STATUS → DURATION Scene status information for test sequence
MANUAL
CONTROL
RESET ACTION Click jog wheel to reset fixture
LAMP ON/OFF ACTION Manually strike/douse lamp
STROBE/SHUTTER → TILT Set each effect manually.
SERVICE
PAN/TILT
FEEDBACK
On
Enable pan/tilt position feedback
systems
Off Disable pan/tilt position feedback
ADJUST
CMY MODULE DIMMER
For use by qualified service technicians –
see Martin service documentation before
entering this menu
EFFECT MODULE SHUTTER
PAN/TILT
MODULE
PAN
TILT
CALIBRATION
PAN/TILT
SENSOR
CALIBRATION
PAN/TILT AT
END STOP
Move pan and tilt to end stops following
instructions in the display, then execute to
calibrate pan and tilt sensors
DIMMER ... TILT
Set individual effects to calibration
positions (approx. +/- 5% offset available)
LOAD DEFAULTS? Load factory default calibration settings
SAVE FACTORY DEFAULT?
Replace factory default calibration settings
with current calibration settings
UPDATE
FIRMWARE
UPDATE
Execute to update fixture firmware from
bank shown in display
BANK Firmware bank version
LOCATION Location of firmware bank
EVENT LOG
EVENT LOG TRIGGER Triggers generation of event log
CLEAN EVENT LOG
Clears event log and any current errors
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 4: Control menus