User manual

28 MAC III Performance user manual
• Whatever type of screw used, the
portion of the screw that goes into the
rear head cover must have a length of
between 12 mm (0.47 in.) and 15 mm
(0.6 in.).
• The rear head cover becomes very hot.
Ensure that handles are insulated well
enough to avoid discomfort or burn
injuries for the followspot operator.
• A handle must only be fitted after
followspot mode is enabled and tilt is
performed manually. Always remove
any handle that is fitted before
disengaging followspot mode.
Besides being constructed so that they
will not foul the yoke at any point in the tilt
range, mounting brackets must match the
dimensions shown in Figure 15.
Dimensions in Figure 15 are shown in
millimeters:
• 216.8 mm = 8.53 in.
• 230.7 mm = 9.08 in.
• 78.9 mm = 3.11 in.
Figure 15: Dimensions for followspot handles