User manual

Control menu 37

(cont.)


Prism off

Prism on, no rotation
 – 
Prism on: rotation CW and CCW; fast, medium and slow


Iris diameter: Press [Enter], then use up and down arrows to select
a value from 0 - 200

Iris closed

Fast opening pulse

Slow opening pulse

Fast closing pulse

Slow closing pulse

Fast random opening pulse

Slow random opening pulse

Fast random closing pulse

Slow random closing pulse
  – 
Focus position
  – 
Zoom position
  – 
Pan position
  – 
Pan position (fine)
  – 
Tilt position
  – 
Tilt position (fine)
 
Run a general test of all effects (for use by service technicians only)

To access
this menu,
hold [Enter]
pressed for
a few
seconds


Enable pan/tilt position correction system. See page 15

Disable pan/tilt feedback. Setting not saved


Enable position feedback from rotating effects. See page 15

Disable position feedback from rotating effects. Setting not saved

See “Adjustment submenu” on page 38

(OF = offset)

Pan calibration (adjustment range: 1 - 255)

Tilt calibration (adjustment range: 70 - 186)

Dimmer calibration (adjustment range: 90 - 170)

Color wheel 1 calibration (adjustment range: 103 - 153)

Color wheel 2 calibration (adjustment range: 103 - 153)

Gobo wheel 1 (rotating gobos) calibration (adjustment range: 103 -
153)

Gobo wheel 2 (static gobos) calibration (adjustment range: 103 -
153)

Focus calibration (adjustment range: 98 - 158)

Zoom calibration (adjustment range: 98 - 158)

Iris calibration (adjustment range: 128 - 255)

Prism calibration (adjustment range: 116 -140)
 
Set all effects to calibration value 128

PCB test: for service use only


Cooling fans: full speed

Cooling fans: temperature regulated
 
Manually set fixture to software update mode
Menu Item Options Notes (Default settings in bold print)
Table 2: Control menu