User manual

Installation 7
I NSTALLATION 3
The T-Rex can be permanently installed or hung with a clamp (not included), or it
can be placed on the floor. For maximum lamp life, do not place the fixture
directly on or beside a speaker cabinet or other source of strong vibrations.
Warning! Block access below the work area before proceeding. Always
use a secure means of secondary attachment.
INSTALLING OR HANGING THE T-REX
1 Install the mounting bracket on
the chassis as shown. Place
the washers on the stud before
the bracket.
2 Verify that the structure can
support at least 10 times the
weight of all installed fixtures,
clamps, cables, auxiliary
equipment, etc.
3 If hanging the fixture with a
rigging clamp, verify that the
clamp is undamaged and can
bear at least 10 times the
fixture’s weight. Bolt the clamp securely to the bracket with a grade 8.8 (minimum)
M12 bolt and lock nut, or as recommended by the clamp manufacturer, through the
clamp hole in the mounting bracket.
4 If permanently installing the fixture, verify that the hardware (not included) and
mounting surface can bear at least 10 times the fixture’s weight. The four 6 mm
holes and the clamp hole in the mounting bracket may be used for attachment.