User manual

Service 11
Installing a lamp in the T-Rex
1 Disconnect the fixture from AC power. If replacing a lamp, allow it to cool for 5
minutes before removing the lamp access cover. The lamp cools faster with the
cover in place.
2 Remove both screws from the lamp access cover and lift the cover off.
3 If replacing a lamp, grasp the old lamp by the reflector and pull it out of the holder.
Then pull the socket off the lamp. Do not pull the wires.
4 Push the socket fully onto the pins of the new lamp.
5 Gently push the lamp into the holder until it snaps into place.
6 Replace the lamp access cover and screws.