User manual

6 DMX Switch Pack
Operation
Apply power
The panel diode lights when power is applied to the DMX Switch Pack.
Control fixtures
Power output 1 is controlled on the first channel, power output 2 is controlled on the second
channel, and so on. To turn a fixture on, set the channel’s DMX value anywhere above 50
percent (DMX 128 - 255). To turn it off, set the value anywhere below 50 percent (DMX 0
- 127).
Maintenance
Replace fuses
If the power diode does not light when power is applied, the main fuse may be blown. The
main fuse is found in a holder next to the power cord; it can be replaced without opening the
cover.
Each power output is fused as well. If one channel does not function properly, the power
output fuse may be blown. The cover must be removed from the unit to access these fuses.
Always disconnect the switch pack from electricity before servicing.
If a fuse blows repeatedly, there is a malfunction with either the switch pack or one of the
fixtures connected to it that must be referred to a service technician. Always replace the fuse
with one of the same size and rating.