Specifications

6 2518 DMX Controller
Connecting a MIDI Device
With a MIDI device connected to the 2518 DMX Controller, you can control lights via
MIDI. Connect the device’s MIDI output to the controller’s MIDI input using a standard
MIDI cable. A standard MIDI cable consists of a shielded twisted-pair and 5-pin DIN con-
nectors wired pin 2 to pin 2, pin 4 to pin 4, and pin 5 to pin 5. The cable shield is connected
to pin 2. Pins 1 and 3 are not used. The cable may be up to 15 meters (50 feet) long.
Connecting to the Power Supply
WARNING!
For safe operation, the controller must be grounded (earthed).
Install Plug
The 2518 DMX Controller is delivered without a plug on the power cord. Following the
manufacturer’s instructions, install an approved 3-prong grounding-type plug that fits your
supply. Connect the wires to the pins as listed below.
If the pins are not clearly identified, or
if you have any doubts about proper installation, consult a qualified electrician.
Wire Pin
Possible Markings
Typical US UK
brown live
“L”
yellow or
brass
red
blue neutral
“N” silver black
yellow/green
ground
(earth)
green green
Table 3: Plug Wiring
2518 IV.BOOK Page 6 Tuesday, September 22, 1998 7:10 PM