Specifications

15Operation
at scene 2.
Auto Trigger Execution
1. Set the trigger rate
: Press [Auto] once to start tim-
ing, wait for the desired trigger interval, and then
press [Auto] again to stop timing.
2.
The scenes execute sequentially. The timer LED
blinks to indicate scene changes as the controller
steps through the bank.
3. Exit:
Press [Auto] again to exit auto trigger mode.
Music Trigger Execution
1. Start execution
: Press [Music]; the Music Trig LED
lights. The controller runs the scenes to the beat of
the music.
2. Exit
: Press [Music] again.
Selecting a MIDI Trigger
Note: A MIDI code may be used either as a trigger or to execute a MIDI scene, but not both.
1. Press [Midi].
The display flashes.
2. Press [Auto]
.
3.
(Optional)
Select a MIDI channel:
Press the up
and down arrow buttons to select a channel
between 1 and 16.
4. Generate the MIDI code:
On you keyboard or
other MIDI device, play the note or execute the
function to use as a trigger.
5.
Repeat steps 1 - 4 to select additional MIDI codes as desired. Up to 2048
MIDI codes may be selected.
6.
See “Deleting a MIDI Scene or Trigger” on page 13 to delete a trigger.
MIDI Trigger Execution
1. Generate the MIDI code.
The scene changes each
time a MIDI trigger is generated.
2.
MIDI triggers remain active until deleted.
Auto
Auto
Music
Midi
Auto
Scene Bank
2518 IV.BOOK Page 15 Tuesday, September 22, 1998 7:10 PM