Specifications

9Address and Mode Setting
If instead we wanted independent control of the RoboColor Pro 400s, another option would
be to control the 2 Destroyers together at the same address and run the 2 Punishers in sin-
gle-channel mode. The fixtures could be addressed as shown in Table 6.
In this setup, there are enough channels to run 2 of the RoboColor Pro 400s in 7-channel
vector mode. The other 2 Pro 400s are running in 5-channel tracking mode; speed control of
these units will not be possible.
Button 1 Button 2 Button 3 Button 4 Button 5 Button 6
Ch Device Ch Device Ch Device Ch Device Ch Device Ch Device
1- 36
1
RoboColor
IIx
7
RoboColor
IIx
13
RoboColor
Pro 400
19 25
RoboColor
Pro 400
31
2814
20
RoboColor
Pro 400
26 32
RoboColor
Pro 400
3 9 15 21 27 33
4 1016222834
5 1117232935
6 1218243036
37- 72
37
RoboScan
812
43 49
RoboScan
812
55 61
RoboZap
MSR 1200
67
6 Channel
Switch Pack
38 44
Destroyer
X250 (2)
50 56
Punisher
62 68
39 45 51
57
Punisher
63 69
40 46 52 58 - 64 70
41 47 53 59 - 65 71
42 48 54 60 - 66 72
Table 6: Another Option (Addresses are shaded)
2518 IV.BOOK Page 9 Tuesday, September 22, 1998 7:10 PM