Specifications

31 LightJockey Help file - (C) Martin Professional 2010
LightJockey Help
Warnings tab
Sequence/Cue Modified - enable to prompt a confirmation box every time before a modified sequence
or cue is overwritten by a clear or load command. Note that the cue modified warning will not be
shown if the cue was loaded as a transparent cue.
Overwrite Sequence/Cue - enable to prompt a confirmation box each time before a saving on top of an
already saved sequence or cue.
Show Blackout Warning - enable this to show a warning when blackout or fade-in or fade-out is active.
Click Cancel on the warning dialog to restore from blackout or fade modes.
Show Freeze Warning - when enabled, a warning is shown when DMX output is frozen.
Show Offline Warning - when enabled, a warning is shown when DMX output is offline.
Confirm Close Program - enable this to show a confirmation dialog when LightJockey is closed.
Quick Save/Load tab - enable sequence/cue/cue list quick save/load.
When quick save/load is enabled, right-clicking will re-save the current sequence, cue or cuelist
without using the save dialog (it requires that the sequence, cue or cuelist has previously been saved -
if not, the case the save dialog will appear as usual).
Likewise right-clicking on any will re-load the current sequence, cue or cuelist (only if a
previously saved sequence or cue or cuelist is currently loaded)
External Links tab
External links - external links allows LightJockey to talk to other Martin Windows applications.
Normally, if not instructed otherwise, leave these options off.
The external links will only be enabled if transmitter hardware is detected.
Enable Offline Visualizer - enables communication to Offline Visualizer - there is normally no reason
to disable this setting other than for trouble shooting purposes. If the option is grayed out it means
that LightJockey cannot locate the Offline Visualizer installation.
Enable link to Sandnet - enables routing of DMX data through Sandnet (tm). Note that this option
requires that LightJockey DMX hardware is installed and configured as well as appropriate Sandnet
hardware and/or software. More information about Sandnet can (at the time of writing this) be found at
http://www.sandsys.com