Specifications

22 LightJockey Help file - (C) Martin Professional 2010
LightJockey Help
The second is to remove the file-type association of the audio CD. The exact method may depend
somewhat on what version of windows is installed, and what type of desktop manager is used. In
general, open any folder and select the "File type" tab. Find the "AudioCD" entries in the "registered
file types" and remove the entry.
Message CD-ROM drive not found
LightJockey cannot detect the presence of a CD-ROM drive - please check Windows installation.
See also audio CD control
MIDI
Select MIDI options from the MIDI tab.
MIDI tab
MIDI Note Commands
A number of functions including latching cues or flashing sequences may be remotely controlled via a
MIDI interface. To enable MIDI remote control of LightJockey via MIDI, enable the MIDI In function on
the MIDI In tab. For more details on the MIDI note implementation see MIDI In.
MIDI Timecode
MIDI time code (MTC) may be used as a time source for cue lists. To enable a MIDI time code
interface, select it from the MIDI device list via the lower right-hand corner (Select from list then click
Select Device). Note that in order for LightJockey to recognize the MIDI device it must be installed
with working Windows drivers.
The MTC Timeout Value determines the time it takes before an MTC driven cuelist times out after
MTC transmission has stopped. Normally, the default value of 0.5 sec is fine, but special
circumstances may make it necessary to increase the timeout value.
External control devices
2532 Direct Access keyboard
Before the 2532 Direct Access keyboard may be used with LightJockey it needs to be configured.
Enable the 2532 Direct Access and then select the appropriate serial port (COM1-COM4). It is not
necessary (or recommended) to enable to enable the 2532 and select a serial port in order to use the
2532 control in virtual mode (using the control without a 2532 physically connected).
NOTE: The 2532 must have at least version 3.0 software in order to work with LightJockey.
Martin 2518 (via RS-232)
Connects the Martin 2518 controller via RS-232. Since the connection is via RS-232 it is possible to
connect the 2518 without additional hardware (except an available RS-232 port and suitable cable).
MC-X Controller
As the MC-X controller uses DMX to communicate with LightJockey, it is only useable with an