Specifications

184 LightJockey Help file - (C) Martin Professional 2010
LightJockey Help
Blackout/Restore function will toggle between blackout and restore each time the key is pressed.
Most functions are either enable or toggle functions.
Flash Functions - a Flash function is a function that is activated as soon as the hotkey combo is
selected, and deactivated when the hotkey key combo is released.
Since the state of the [Shift] and [Control] keys are read at the point where the 'main' hotkey is
pressed, make sure to press and the [Shift]/[Control] keys before the 'main' key and to release the
[shift]/[Control] keys after the 'main' hotkey has been released. Or avoid using [Shift]/[Control]
functions for flash functions. Flash functions are marked with an *. Note that due to the nature of the
PC keyboard, it may be impossible to hold more than a couple of keys down in flash mode before the
keyboard buffer runs full and the keyboard stops responding.
System functions
Close Window - Closes the current active LJ window (except the main LJ desktop)
Close All Windows - Closes all LJ windows (except the main LJ desktop)
*Freeze Output - see freeze output. Freezes the DMX output values while the key is held down. Fade
calculations and movement macros are stopped, but sequences in cues are still trigged. (flash
function)
Freeze Output Toggle - see freeze output - the mode toggles on and off for each key press.
*Freeze + B/O - Combines freeze and Blackout command (flash function)
Freeze + B/O toggle - Combines freeze and Blackout command - toggles on and off for each key
press.
DMX Offline, DMX Online, DMX OnLine/OffLine toggle - see offline/online switch
2532 Control - Toggles the 2532 control
Virtual Fingers - use to toggle virtual fingers
Fingers status panel - use to toggle fingers status panel
Intensity functions
Toggle Master Intensity Control - Toggles the master intensity control on and off
Blackout/Restore - Toggles blackout/restore (as the blackout button)
Blackout - Sets Blackout
Restore - Restore from blackout
Fade Out/Fade In - Toggles the fade out / fade in states, using the fade time set in the master
intensity control
Fade Out - Starts a Fadeout using the Master Intensity fade time.
Fade In - Starts a Fade in using the Master Intensity fade time.
Fade Out 1-10 Sec / Fade In 1-10 Sec - Starts a fade out or fade in using the specific time.
Master Intensity off/full/+1/+10/-1/-10 - Immediately sets or modifies the level of the intensity master -
note that when using a hotkey for 'fading' by holding down a key on the keyboard, the 'fade time' is
determined by the system keyboard repeat rate.
*BlackOut - Sets Blackout for as long as the key is held down - when the key is released the output
is restored.
*FadeOut - Activates fadeout for as long as the key is held down - when the key is released a fade in
is performed. Both fade out and fade in use the default fade time selected on the master intensity
control.
*Bump Master, *Bump Sub 1-8 - bumps the individual master intensity faders (Flash Function).
Toggle Bump Master, Toggle Bump Sub 1-8 - toggles bump status on the individual faders on the
master intensity.
HTP groups
*HTP group X - Bump - Flashes the channels belonging to the HTP group to On (DMX value = 255).
HTP group X - Toggle - Toggles the channels belonging to the HTP group between On (DMX value =
255) and Off (DMX value = 0).
Fixture controls
Fixture controls (Intensity -> Level/Special) - Toggles the individual fixture controls - fixture controls
will only be shown if they are valid for the current, selected master fixture
Toggle Intensity Palette -> Toggle Levels/Special Palette - Toggles the corresponding user palette on