Specifications

114 LightJockey Help file - (C) Martin Professional 2010
LightJockey Help
Hotkey Trig Changes Sequence Direction - When enabled, hotkey trigs (e.g. trig bounce slot#) will
change the sequence loop direction according to the direction given by the hotkey trig. Note that
manual trigged sequences in chase mode will always change the trig direction according to the latest
hotkey press.
Cue Preferences
Disable BG Cue Latch - Disables the ability to latch background cues from the cue
Release Current Sequence on Load - When enabled, the current sequence is automatically cleared
whenever a new cue is loaded (disable the sequence changed warning to avoid warnings when the
sequence is cleared)
Restore Sequence Enabled State - restores the sequence enabled/disabled state as set when the
cue was saved
Save Chase Times - chase times for manually trigged sequences are saved with the cue, see trigging
sequences in the cue
Disable Fade Times in Chase Mode - sequences in chase mode have their fade times disabled,
effectively snapping all effects, see trigging Sequences in the cue.
Allow Remote Enable/Disable - when this option is disabled, remote sequence on/off commands (e.g.
via DMX in) are not accepted by the cue control.
Restore Macro Control Values - this option must be enabled to restore saved macro control values
when reloading the cue. If not checked saved values are ignored when loading the cue.
Show Scene time as BPM - when enabled, scene time is displayed as BPM (beats pr minute) rather
than the usual time format.
Transparent Cues - see transparent cues
Sequence Intensities - see sequence intensities
See also background cues, transparent cues, sequence intensities, cue-builder, generic DMX macros
Save cue dialog
This dialog is used when saving a cue. The dialog is opened when clicking located on right hand
side of the sequence/cue tool bar and in the cue control.
Save cue dialog
Cue # - a number that is used to uniquely identify the cue. The number is applied by the LightJockey
when saving the cue for the first time, so for a new cue this field will be blank until the cue is saved.
Cue name - this is a name for the cue that will be used through out LightJockey. The name can be
changed at any point, providing that the cue is saved after the name has been changed. The name
has no other function than identifying the cue to the user.
Cue Type - It is possible to assign a pre-defined cue type to the cue. Currently the cue type is
reserved for future use.
Save as Transparent Cue - when checked the cue is saved as a transparent cue.
Save Macro Control Values - when checked the cue macro control values are saved with the cue.
Clear after Save - when checked the cue is automatically cleared after being saved.
Add To Cuepage - automatically add the cue to a specific page in the list of cues. If a cue is already