User manual

18 RUSH MH 4 Beam User Manual
• OFF IF DMX OFF sets the lamp to power off automatically as soon as a
DMX signal is not present
Ignition delay
If a large number of fixtures power their lamps on at the same time, voltage
drops can result. To spread the load across multiple fixtures, an ignition delay
of 0 to 255 seconds can be set, so that there is a delay between power on and
lamp on.
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select IGNITION DELAY and press
ENTER to confirm.
3. Use the DOWN and UP buttons to specify a delay duration in seconds.
4. Press ENTER to confirm (or to return to the previous menu level without
making a change, press MENU).
Low power delay
In a low-power delay, when a lamp off command is sent the lamp runs at half
power for a period before powering completely off:
1. Select LAMP SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select LOW POWER DELAY and
press ENTER to confirm.
3. Use the DOWN and UP buttons to specify a duration.
4. Press ENTER to confirm (or to return to the previous menu level without
making a change, press MENU).
Display settings
Invert display
Inverting the display is useful if the fixture is hung from a truss or from
elevation. To invert the display:
1. Select DISPLAY SETTINGS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select DISPLAY INVERSE and press
ENTER to confirm.
3. Use the DOWN and UP buttons to select the YES (invert).
4. Press ENTER to confirm (or to return to the previous menu level without
making a change, press MENU).
Automatically turn off display backlight
The display backlighting remains on permanently by default when power is
applied to the fixture. If you prefer, you can enable Sleep mode, where the