User manual

Summary of control functions:
Setting Description Actions required Display
DMX address Sets the unit’s DMX
address
Press
‘UP’ or ‘‘DOWN’ once to increment/
decrement the value, hold down the ’UP’ or
‘DOWN’ for fast forward/reverse.
Note: -
The unit uses 1, or 2 DMX channels depending on
which control mode it is set for (see below).
(See also, DMX addressing instructions)
Fan speed
Sets the fan speed There are four fan speeds, 1 is the slowest, 4 is the
fastest and a remote option. The unit uses 1 DMX
channel when a numbered fan speed is selected.
Selecting Fnr automatically places the unit in two
DMX channel mode, and allows the fan speed to be
controlled by the second DMX channel.
Press
‘UP’ or ‘DOWN’ once to increment/
decrement the value,
(See also, fan speed instructions)
‘Gel Saver’
Switches on/off the gel
saving mode.
Press
‘UP’ or ‘DOWN’ once to switch between on
(1) and off (0).
Note: -
Ensure that the gel is centered (by channel/DMX
value) before implementing this mode, or the next
color may show through during the gel saver mode.
(See also, gel saver mode instructions)
‘speed’
Sets the scrolling
speed
There are two scrolling speeds. 1 is the normal
speed, 2 is the fast speed.
Press
‘DOWN’ or ‘UP’ once to increment/
decrement the value,
(See also, gel scroll speed instructions)
‘disPlay’
Switches display on/off
Press
‘UP’ or ‘DOWN’ to switch between on (1) and
off (0).
Display will re-activate when any button is pressed.
(See also, display mode instructions)
Light
activated
Fans
Allows light output to
control the cooling
fans.
Press
‘UP’ or ‘DOWN’ once to switch between on
(1) and off (0).
(See also, fan mode instructions)
reSet
Resets the unit to the
default settings.
While holding down
‘ACTION/RECALL’ button,
press the
‘UP’ button.
(See also, reset instructions)
Atomic Colors User Manual Operating the unit 18