User manual

MPU-02 Connection Procedure
1. Rig the combined Atomic 3000 DMX and Atomic Colors fixture in the desired position,
ensuring that you use the safety wire as a secondary means of attachment.
2. Connect the power/data output on the MPU-02 to the power/data input on the Atomic
Colors with an XLR-4 cable.
3. Connect the MPU-02 to the main data link using the XLR-5 input. You can, for example,
run a 5-pin XLR cable from the DMX output of an Atomic 3000 DMX to the input of the
power supply. For more information on building a data link, please refer to the Atomic
DMX 3000 user manual. Continue “daisy-chaining” the DMX link by connecting the 5-
pin DMX thru socket on the power supply to the next Atomic 3000 DMX, power supply,
or other fixture.
4. Connect a second Atomic Colors unit, if desired, to the first unit using the second XLR-4
socket and an XLR-4 cable.
5. Connect the MPU-02 and the Atomic 3000 DMX units to the AC supply.
Note: Before operating the Atomic strobe, make sure the power supply for the Atomic
Colors is connected, and switched on.
System connections using the MPU-02 power supply.
Atomic Colors User Manual Connecting the unit 11