User guide

Assembly Instructions
STEP 4] Attaching Tilt Mechanism
Take the [2] Tilt Mechanisms (part I) and attach the one end
as show in FIG 4 to the Top Support (part F) using [2] 6x28mm
bolts (part P) and [2] nuts (part S) per tilt mechanism. Tighten
with wrench (part U) and Allen Wrench. Repeat with other
mechanism. See FIG 4.
FIG 4
FIG 4B
STEP 4B] Attaching Drawer Supports
After the previous steps, the Assembled Base should now
look like the picture shown at left if proper assembly was
completed.
Continue with assembly on next page.
I
S
P
H
Pg. 3
F
B
NEW U-DS90W/U-DS90B Creation Station
K
T
V
P
Revised AUGUST 09
Attach drawer support(part H) to drawer support rod
(part K) using(part P) 6x2 8mm bolt. Continue by
attaching drawer support (part H) to upper
(part B) using (part T) 6 x65 mm add (part V) between
upper base end and ( part H) drawer support. Repeat
assembly with the remaining drawer supports.
SEE FIG 4B
base end