User manual

Optical configuration 33
Effect wheel
The effect wheel provides a variable frost filter and two positions for effects. The MAC 2000 Performance II
comes with a wide angle lens and a nine-fact prism installed in these positions.
Replacing effects
1 Disconnect the fixture from power and allow it to cool.
2 Lock the head in the upside down position and remove the bottom cover. Turn the effect wheel so that the
locking plate is under the sensor bracket.
3 To remove, hold the rim of the effect holder and pull back on the locking plate. Remove effect from wheel.
4 To insert, pull back on the locking plate. If both effects are removed, pull straight back on both tabs. Position
the groove in the effect holder over the fixed plate. Release the locking plate and verify that the effect is
properly seated.
5 Replace the bottom cover and unlock the head before operating.
Gobo animation
The following gobo animation wheel patterns are supplied with the MAC 2000 Performance II.
Open position
9-facet prism
Wide angle lens
(beam expander)
Variable frost filter
Locking plate
Position the effect holder
groove over the fixed plate.
DHA 18DHA 13DHA 12 (installed)DHA 11
DHA 16
Tangential breakup Cloud breakup Dot breakup
Radial breakup
Spiral breakup