Owner manual

RVC 2-25 CD&
6 Operation
Version 11/2008, Rev. 2.2 of 04/12/2013 • sb
45
Translation of the original operating manual
Creating a new program
A new program can be created based on a fixed program template and
adapted to specific needs by changing the set values and by adding and
deleting certain sections. The control system automatically assigns a
program number to every new program.
Select "New program" from the menu "Program administration" (see
figure) and confirm. The following message will appear:
Fig. 32: Message "New program created"
Press the right-hand function key to confirm.
Continue as described under "Editing a program" (see below).
Editing a program
Select "Edit program" from the menu "Program administration" (see
figure) and confirm. The program list is shown.
Fig. 33: Program list
Select a program from the program list.It will be opened for editing.
Open the menu "Program parameter" in order to change the program
name. Use the functions keys to position the focus in the program
name. Use the up/down keys to change the character at the current
focus position.
At the last position of the program name, the right-hand key function
changes to "ok" to enter the program name.
Fig. 34: Changing the program name
The sections of a program can be adapted under "Edit program sections".
The set values and sections are displayed in a tabular form.
Fig. 35: Program section table