Owner's manual

RVC 2-18 CD&
6 Operation
Version 04/2012, Rev. 1.3 of 25/11/2013 • sb
29
Translation of the original operating manual
Pos: 102 /20 0 Chri st/3 70 RVC -BA (S TA NDA RDMODU LE) /06 0 Betri eb/0 60 Bet rieb == ===== ==== ===== == ===== ===== == ==== ===== = @ 8\mo d_1 309 426563 173 _68. docx @ 46 735 @ 1 @ 1
6 Operation
Pos: 103 /20 0 Ch rist/3 70 RV C-BA (S TA NDA RDMODU LE) /06 0 Betri eb/0 60- 001 0 Erste In bet rieb nah me+ ++++ +++++ ++ +++++ +++++ ++ ++ @ 8\ mod _13 094265 6354 8_6 8.d ocx @ 4674 3 @ 2 @ 1
6.1 Initial start-up
WARNING
Before the initial start-up, please ensure that your RVC is properly set up
and installed (see chapter 5 - "Set-up and connection")
Pos: 104 /01 0 Univ ersal module/ Lee rzeile @ 0\ mo d_12021 162445 00_ 0.docx @ 1 14 @ @ 1
Pos: 105 /20 0 Ch ri st/3 70 RV C-BA (S TA NDA RDMOD ULE )/06 0 B etri eb/0 60- 002 0 Ei nsc halte n+ +++ ++ +++++ ++ +++++ ++ +++++ ++ ++++ +++ ++ ++ @ 8\ mod _13 0942 656 454 8_6 8.doc x @ 4 676 7 @ 2 @ 1
6.2 Switching the RVC on
• Press the mains power switch on the right-hand side of the unit.
The CD
plus
control unit performs a self-test and an initialisation. This may
take several seconds.
• Follow the safety instructions and hazard warnings !
Pos: 106 /01 0 Univ ersal module/ Lee rzeile @ 0\ mo d_12021 162445 00_ 0.docx @ 1 14 @ @ 1
Pos: 107 /20 0 Ch rist/3 70 RV C-BA (S TAN DAR DMODULE ) /06 0 Betri eb/0 60- 0030 Ö ffne n un d Schli e ßen des D eck els @ 8\ mod_13 094 270 445 54_6 8.d ocx @ 46791 @ 2 @ 1

6.3 Opening and closing the lid
The lid can be opened if the rotor chamber is aerated and if the rotor is at a
standstill. The rotational vacuum concentrator cannot be started if the lid is
open.
• Select "mode" with the left-hand function key.
• Select "Open lid" with the up and down keys.
• To close, press slightly on the lid until both locks are locked.
DANGER
Do not place your fingers between the lid and the housing when closing
the lid. Risk of crushing!
Pos: 108 /01 0 Univ ersal module/ Lee rzeile @ 0\ mo d_12021 162445 00_ 0.docx @ 1 14 @ @ 1
Pos: 109 /20 0 Ch rist/3 70 RV C-BA (S TAN DAR DMODULE ) /06 0 Betri eb/0 60- 0040 Ei ns etzen von R oto ren und Zu beh ör--- --- ----- ----- --- ----- ----- --- ----- - @ 8\m od_ 1309 498 541 224_68. doc x @ 46 808 @ 2 @ 1

6.4 Installation of rotors and accessories
Pos: 110 /20 0 Ch rist/3 70 RV C-BA (S TAND ARD MODULE )/06 0 B etri eb/0 60-004 0-0 010 E insetz en v on Wi nk elrot oren @ 8\m od_ 130 9496686 889 _68. docx @ 46 801 @ 3 @ 1

6.4.1 Installation of angle rotors
• Only use inserts that are suitable for the rotor (see chapter 11.1 -
"Rotor program").
• Always load the opposite inserts of the rotors with the same accessories
and fill to avoid imbalance.
• Push the loaded rotor onto the rotor shaft until it reaches the stop.
NOTE
Depending on the version, up to three rotors can be pushed onto the rotor
shaft at the same time.