Owner manual

AdjustingtheTRG
Tofunctionproperly,thecablesrunningthrutheTRG
should travel freely all the way to full draw without
long-termcontactwiththeendofthecableslot.With
some longer draw lengths, thecable may reach the
end of the slot before the archer reaches full draw,
allowingthecabletorubagainsttheendoftheslot.
Whenthisoccurs,asmalladjustmentcanbemadeto
extendtheTRGrodoutfromtheriser.First,pullthe
cablesoffoftheTRGandaroundtothesightwindow
side of the unit.  Next, loosen the twoAllen screws
securing the rod to the riser and slide the rod
outward.Averysmalladjustmentisallthatisrequired.
(Bothscrewsshouldremaininfullcontactwiththerod
whenre-secured.)Tightenthescrewsandreinstallthe
cablestotheirslotsontheTRG.
8
Basic Setup
InstallingandAdjustingtheDrawStop.
 There are a total of four parts to the Draw Stop
assembly.Arubbercap,thealuminumbodyoftheDraw
Stop,an8/32screwandan8/32hexnut.Toinstallthestop,
placethehexnutinthetrackonthebacksideofthecam.
Toadjustthestop,drawthebowbackeitherbyhandorina
scale/shootingmachine.Atfulldraw,slidethestopuntilit
contacts the under side of the limb. Back the
stop off of the limb 1/32” (appox.) to allow for the
rubber cap to be installed. Snug down the Draw Stop
with the appropriate Hex head wrench, and install the
rubbercapovertheDrawStop.
Note: Some versions of the Acu-Trak and C.A.T. cams have numbered draw
stop tracks which have no correlation to the draw module number or draw module
position numbers.
InstallingandAdjustingtheSTS
 MostMartinbowsareoutttedwithanSTSStringDampeningunit,orareequippedto
acceptone.Thisunitisinstalledinthe3/8”diameterholelocatedjustbelowthegripand
issecuredinplacewiththesetscrewintersectingthisholefromthesideoftheriser.The
STSrodshouldbepositionedsothattheSTSBumperisnearlyagainstthebowstringwhen
thebowisatrest.ExcessivecontactwiththebowstringwillpreventtheSTSBumperfrom
performingeffectivelyasadampener,andmaycausetheBumpertobepulledoffbythe
bowstringduringtheshot.Asmallgap(approximately1/16”)shouldbeallowedbetweenthe
bowstringandBumperwhenthebowisatrest.
DrawStop
InPlace
Correctcableplacement
withbowatrest.
Cablestoofartowardsthebackof
theTRGwiththebowatrestfor
somelongerdraws.