Compound Bow Manual & Warranty Registration *MUST REGISTER BOW WITHIN 90 DAYS FOR FULL WARRANTY
Owner's Record - Critical Information Bow Model:__________________________________________________________________ Date Purchased:__________________________________________________________________ Cam Style:__________________________________________________________________ Draw Weight:__________________________________________________________________ Draw Length:__________________________________________________________________ String Length:__________________________________________________________________
Basic Setup Your new Martin bow takes little setup to get started shooting. Please read and familiarize yourself with these starting procedures before shooting. Many of these procedures may have been completed by your authorized Martin dealer. After completing these simple steps, you will be more accurate and will have greater success from the start. A careful and thorough initial setup will make the tuning process much easier.
Basic Setup Care And Storage When properly cared for, your new Martin bow will give you years of trouble-free service. When your bow is new it will require no lubrication. Over time you may need to lubricate your cams to guard against friction and noise. Use a dry lubrication such as Teflon spray powder or graphite powder. You can also use wet lube such as Moly Lube or Tri-Flow. Do not use WD-40 lubrication. A good rule of thumb when caring for your bow is to keep it as comfortable as you are.
Ghost 2.0 Cam System The Martin Ghost 2.0 Cam system features a rotating module for draw length adjustments in half-inch increments. This cam system also features an adjustable draw stop for a customized valley and solid stop. Parts Of The Martin Ghost 2.0 Cam Sytem MODULE SCREWS DRAW STOP SHOOTING STRING ANCHOR DRAW STOP MODULE SCREWS MODULE SETTING MARK MODULE SETTING MARK LIMB ALIGNMENT HOLE Top Cam Bottom Cam Adjusting The Ghost 2.
Silk Cam System The Martin Silk Cam system feature a modular draw length adjustment. The draw length module is used to adjust draw length in 1/2" increments (see below). Adjusting the draw weight can also be adjusted by moving the limb bolts out or changing the string position. Parts Of The Silk Single Cams System Adjusting The Single Cam Draw Length Using draw length modules, the draw length can be adjusted in 1" increments.
Equalizer Cam System The Martin Equalizer Cam system features two rotating modules for draw length adjustments in inch increments as well as let off adjustment. This cam system also features an adjustable draw stop for a customized valley and solid stop.
Ghost Cam Tuning Ghost 2.0 Cam Tuning Instructions For correct tuning, adjust the strings to keep a equal tiller measurment and make sure the cam alignment holes sit directly under the limb on both top and bottom cam at rest. (SEE BELOW) Tiller measurments should be exactly the same on top to bottom when measuring from limb pocket to draw string. Setting Your Nock Point Set the Nock from 1/6" - 1/4" high off arrow rest center (SEE BELOW) Notice the allignment of the cams with the limb.
Ten Commandments Of Archery Safety Never Never Never Never Never Always Always Always Always Always “Dry fire" your bow (shoot it without an arrow.) This will result in damage to your bow and/or possible injury. Let anyone draw or shoot your bow if their draw length is longer than yours. Over drawing of the bow can cause cable damage. Draw, aim, or shoot your bow unless you are sure that the line of fire is clear.
Warranty MARTIN COMPOUND BOW WARRANTY What is the warranty? Martin Archery warrants that your Martin compound bow will perform its intended function if used in accordance with the instructions provided. Who does the warranty cover? The warranty covers the original purchaser of the bow and is not transferable. What does the warranty cover? This warranty covers the replacement parts, labor, and ground transportation costs for return of the bow to the customer.
