iOS User Manual

Note: An app must be both installed on your phone AND turned “on” in
Notification Center, for you to be able to receive notifications from that app.
See “RECEIVING INCOMING NOTIFICATIONS” section for instructions.
Setting Alert Filters – Here you can choose which alerts from your phone’s
Notification Center you want to have forwarded to your watch. When you
open the Martian App Alert Filter tab, you’ll see that the toggle switches are
set to “ON” (green) by default. But, remember, your Alerts Filter will show
apps that are not installed in your phone’s Notification Center. If these show
as turned ON, it is of no consequence. To allow a notification on the watch
that is already set to send notifications from your phone’s Notification
Center, tap the toggle switch to change it to “ON” (orange).
Customizing Vibration Patterns – Custom vibration patterns allow you to
discern the difference between alerts even without looking at your watch.
Each pattern uses up to four placeholders, with each placeholder able to
trigger a short (S), long (L), or delay (D) signal to create a pattern.
Martian has established general default patterns to give you a start in
setting your own patterns. The default pattern for alerts generated by the
phone will start with a Short vibration (e.g. calendar, reminder, etc.), while
the default pattern for alerts generated by incoming messages start with a
Long vibration.
To further customize these settings:
Tap on the app name for which you want to create a custom pattern.
Scroll to choose a pattern up to 4 characters long. Use “Pause” if you want a
pause during the pattern. Choose “Done” at any point and the pattern will
stop. For example, choose “Short Pause Long Short” and your vibration
pattern will be “short-pause-long-short”. “Short Short Done” will be short-
short.
Test your pattern after you set it up by holding your watch and tapping
“play” on the App.
When you are satisfied with the pattern you created, tap “Save” in the upper
right corner of the App.
!
Display Tab