User manual

pdfcrowd.com
Incoming Text Messages:
When receiving a text message, the Watch vibrates once, the blue light flashes, and the name or
number of the sender is displayed on the Watch OLED.
To stop an incoming text message from displaying on the Watch, press the bottom button or tap
the Watch face. To recall the most recent message within 5 minutes tap the Watch face.
If your mobile device supports Voice Commands, tap the top button and after the beep say “read
text”. The last text message received will be read back to you.
Outgoing Text Messages:
If your mobile device supports Voice Commands for sending Outgoing Text Messages, speak
those commands into your watch. See your mobile device’s Voice Command instructions for the
specific commands to use.
ADDITIONAL HELP
To reset your watch, plug the USB cable into a power source. Connect the USB cable to the Watch
and immediately disconnect it again.
Turn on your Watch then, press and hold both buttons on the Watch until the word “Restored”
appears.
TROUBLE SHOOTING
Your OLED display stop working, but the LED & vibration are working
Plug in your USB cable to the Watch, then quickly remove it. This resets the software and should
resolve your problem.
With Android phone, getting a call from Sue Anders but the watch shows another
contact, Sue Anderson
If you have 2 contacts in your address book and one includes the complete name of another (“Sue
Anders” is also part of “Sue Anderson”), some phones are unable to determine and transfer the
correct contact’s ID to your watch. If this occurs, add a differentiator to the shorter name (for
instance, change “Sue Anders” to “Susan Anders”) so the two names have a difference in them.
When Bluetooth feature on and off, and the green light on your watch starts blinking.