User guide

pdfcrowd.com
When finished with the conversation, press the top button to end the call. The OLED
will display “Call Ended”.
Outgoing Call:
Tap the top button. The Watch LED light will flash green to acknowledge a Voice
Command request. Wait for the Watch to Beep then speak the desired Voice
Command supported by your mobile device for Outgoing Calls.
NOTE: The Outgoing Call feature is available on your watch only if your mobile device
supports Voice Commands for Outgoing Calls.
Call Volume and Mute:
To change the Volume of a call on the Watch press the bottom button to set the
preferred Volume. The volume options are: Low (1), Medium (2), High (3) and Clear
Voice (C).
At the Clear Voice (C) volume, a tap of the bottom button will cause the Watch to
vibrate indicating that the Watch is at the Clear Voice setting. Tap the bottom button
again to reach the Low (1) setting.
To mute the Watch microphone during an active call, press and hold the bottom
button until the “mute” (microphone with a line through it) icon appears on the OLED
display. To un-mute press and hold the bottom button again until the “active”
microphone icon appears.
Text Messages
Incoming Text Messages:
When receiving a text message, the Watch vibrates once, the blue light flashes, and
the name or number of the sender is displayed on the Watch OLED.
To stop an incoming text message from displaying on the Watch, press the bottom
button or tap the Watch face. To recall the most recent message within 5 minutes tap
the Watch face.
If your mobile device supports Voice Commands, tap the top button and after the
beep say “read text”. The last text message received will be read back to you.
Outgoing Text Messages:
If your mobile device supports Voice Commands for sending Outgoing Text
Messages, speak those commands into your watch. See your mobile device’s Voice
Command instructions for the specific commands to use.