Manual

DPM 2AS-BL 3½ Digit Backlit LCD Voltmeter Module
CIRCUIT DIAGRAM
www.lascarelectronics.com
PIN FUNCTIONS
1. V+ Positive power supply to the meter.
2. GND 0V power supply to the meter (3.0to 7.5V meter powersupply applications only).
3. V- Negative power supply to the meter (6.0 to 15.0V meter powersupply applications only).
4. BL- Connectto the meter's negative supply voltage to switch onthe LED backlighting.
For meter supply voltages above 5V, add a series resistor Rs.
See Applications for suitable circuit diagrams.
5. INHI Positive measuring input.
6. INLO Negative measuring input.
7. DP1 Connect to XDP to display DP1 (199.9).
8. DP2 Connect to XDP to display DP2 (19.99).
9. DP3 Connect to XDP to display DP3 (1.999).
10. XDP Connect to pin 7, 8 or 9 to display required decimal point.
A negative supply is generated internally and mirrors the positive supply. For example: if V+ is +5V, then
the internally generated V- is -5V. When measuring with the input referenced to the same supply rail as
that of the panel meter, then the limitations on the input range are (V- + 1.5V)to (V+ - 1.5V).
LCOM Normally Open. Connects INLO toCOM.
LXDP Normally Closed. Cut this link to disable the internal decimal point drive circuit and thereby
reduce the meter's current consumption.
Note:
Solder Links:
www.martelmeters.com
page 3 of 4