Owner's manual

6.5 Remote Commands and Error Codes

The following tables list all commands, and their descriptions, that

are accepted by the calibrator.

Table 5: Common Commands

Command Description

*CLS (Clear status.) Clears the error queue.

*IDN? Identification query. Returns the manufacturer, model num-

ber, and firmware revision level of the Calibrator.

*RST Resets the calibrator to the power up state.

Table 6: Calibrator Commands

Command Description

DAMP Turns Damp on or off.

DAMP? Returns if DAMP is on/off

DISPLAY Turns on/off the displays specified in the command

DISPLAY? Returns which displays are on/off

ERROR_LOOP Turns loop power on or off in percent error mode

ERROR_LOOP? Returns the current state of loop power in error mode

ERROR_MODE Turns percent error mode on or off

ERROR_MODE? Returns whether percent error mode is on or off

ERROR_PORT Set the pressure port for percent error mode

ERROR_PORT? Returns the pressure port for percent error mode

FAULT? Returns the most recent error code

FUNC Sets the display mode as specified in the command

FUNC? Returns the current mode of the upper, middle, and lower

display

HART_ON Turns the hart resistor on.

HART_OFF Turns the hart resistor off.

HART? Returns the current state of the Hart resistor.

HI_ERR Sets the 100% of span limit for percent error mode

HI_ERR? Returns the 100% of span limit for percent error mode

IO_STATE Set the calibrator's mA state.

IO_STATE? Return the calibrator's mA state.

LOCAL Returns user to manual operation of the calibrator