User Manual

PAGE 1
GEM RF CONTROLLER SYSTEM SPECIFICATIONS 1 Supply Voltage: 3 Relay Contact Load 4VACDC Rating: 1 AMP @ 24VAC/DC: 2: Frequency: 303 MHz 4, Transmitter powered by 9 Volt battery. DESCRIPTION The Gem two-channel RF controller system is designed for use with an operator controller that is provided with a “Constant Pressure” mode of operation. The motor will run in the direction selected by the activated push-button until the push-button is released. When the push-button is released the motor shall stop.
PAGE 2
RECEIVER BOARD INSTALLATION PART #8-5002-GEM The receiver board is provided with & 24” long color-coded harness Tor interconnection of the receiver board: with the motor control boded of the operator, 1 Black Wire: 24 VAC/DC Positive power supply connection and cotton tithe control relays, 20 White Wire: | 24VAC/DC Negative power supply connection. 3. Red Wire: | Normally open Relay output to Down direction: 4; Yellow Wire: Normally pane Relay output to Up direction. 5.