Mobile UHF Reader Quick Guide CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the partresponsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
OUT OF THE BOX INTRODUCTION Function Button Trigger Button LED Indicator 1 Mobile UHF Reader 2 Quick Guide Micro USB port Mobile UHF Reader Quick Guide SPECIFICATIONS Frequency Standard Read Range Memory Housing Weight USB Charger Cable -3- Neck Strap 915 MHz (US)/ 868 MHz (EU) EPC Gen2/ ISO 18000-6C Up to 100CM (3.3ft.) 2MB PC + ABS 103.5g (w/ battery) Profile/Interface BT HID, BT SPP, USB HID, USB VCP Battery Life 6000 scans Charge Time 4 hours (fully charged) Radio Bluetooth 2.
BEEPER INDICATION READING RFID TAGS Single long beep Single beep Two beeps Power up Good read i. Wireless connection ii. The reader successfully enters or exits configuration mode Three beeps Wireless disconnection Three short beeps The reader reads a tag while disconnected. Four beeps (Hi-Lo-Hi-Lo) Out of range/Poor connection Five beeps Low power Below figures show the optimal orientation of reader and RFID Tag for reading.
POWER UP SHUT DOWN Press the Trigger Button for 2 seconds. The unit will emit one (1) long beep and light the LED red as confirmation that the reader has successfully powered up. METHOD 1: By default, the unit shuts down automatically after 5 minutes of inactivity. METHOD 2: Using a needle or paper clip, press the Reset Button located at the bottom of the reader once. This will force a shut down.
GETTING CONNECTED Connecting to a PC/ Notebook Connecting to an Apple iOS Device 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 2. Enter the PC/Notebook’s Bluetooth application, and click “Add a Device”. 2. On the Apple iOS device, go to Settings > Bluetooth, and turn on Bluetooth. 3.
GETTING CONNECTED Connecting to an Android Device 1. Press and hold the Trigger Button for 2 seconds to power up the unit, after which the blue indicator LED will flash continuously. 2. On the Android device, go to Settings > Bluetooth, and turn on Bluetooth. 6.
DEFAULT RFID SETTINGS RFID UTILITY Operation Mode = Trigger Mode Read Tag Mode Tag Info Tag List Counter = Single Tag = EPC Code = 64 RFID Utility enables you to configure the reader with your PC/Laptop via USB connection. For more information on RFID Utility , please contact your local distributor.
