Operating Guide

12 of 20
104 S. 8th Ave. Marshalltown, IA Phone [phone] • Fax [phone] www. MARSHALLTOWN .com
WS1213
9-2018/Rev.D
ASSEMBLY GUIDE (Attach Drum)
8. Connect drum to output drive shaft (align drum over set screw) Hardware required: SET 5
Align set screw using a standard screwdriver,
perpendicular to mixer frame. See Inset A
Drum will straddle set screw and fit tightly
on motor spindle.
Two washers placed on bottom of drum, secured with bolt. Use a 22mm socket to tighten drum to motor spindle.
Assembly is easier with frame laying flat as shown.
Inset A