VBA 400 VALVE BASS AMPLIFIER
ENGLISH Pages 6-10 DEUTSCH Pages 11-15 FRANÇAIS Pages 16-20 I would like to personally thank you for selecting our VBA400 valve bass head. VALVE BASS AMPLIFIER ESPAÑOL From the Chairman VBA 400 ENGLISH Pages 1-5 Since I started Marshall Amplification in 1962 I have witnessed some incredible breakthroughs and advances in amplifier design technology, however there is an inescapable magical tone that comes from using a traditional Marshall valve amplifier.
A B C D E F G H I J WARNING! - Important safety instructions WARNING: This apparatus must be earthed! PLEASE read this instruction manual carefully before switching on. ALWAYS use the supplied mains lead, if a replacement is required please contact your authorised Marshall Dealer. NEVER attempt to by-pass the fuses or fit ones of the incorrect value. DO NOT attempt to remove the amplifier chassis, there are no user serviceable parts.
may give you the sound that you are trying to capture. If you are using a Tuner in-line via item 1 on the rear panel, you should still use one of these inputs to connect your bass. 13. Passive This input is designed to take the signal from a passive bass. If your bass guitar is passive plug it in here. We recommend that you always use a high quality screened cable for this to help prevent noise, interference and unwanted feedback. 14.
VBA400 Front Panel OUTPUT CONTROL OFF EQUALISATION 1 OFF 2 INPUT D.I. 3 VBA 400 VALVE BASS AMPLIFIER ON DEEP ON POWER 0 STANDBY BRIGHT 10 MASTER VOLUME PRE MUTED ON/OFF 0 10 TREBLE 0 10 CONTOUR SELECT MIDDLE 0 10 BASS 0 POST TUNER MUTE 10 GAIN PASSIVE ACTIVE 13 14 12 1 2 3 4 5 6 7 7 8 9 10 11 8 10 11 12 VBA400 Rear Panel CAUTION!: TO REDUCE THE RISK OF FIRE REPLACE FUSES WITH THE SAME TYPE AND RATING ONLY. DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE.
