DRP-1 Direct Recording Pre-Amp
ENGLISH FROM THE CHAIRMAN I would like to thank you personally for selecting one of our Direct Recording Pre-amps. In our quest to make the sound of Marshall more accessible, we constantly use the knowledge and experience of our Research and Development team to produce new products. Following the success of the SE100 Speaker Emulator and PB100 Power brake, we have now produced the DRP-1 Direct Recording Pre-Amp.
ENGLISH WARNING! PLEASE READ THE FOLLOWING LIST CAREFULLY A. DO NOT attempt to remove the DRP-1 chassis. There are no user serviceable parts inside. B. ALWAYS have this equipment serviced or repaired by competent, qualified personnel. C. PLEASE READ this instruction manual carefully before switching on. DRP-1 Direct Recording Pre-amp.
When activated by the switch (Item 7) the LED will illuminate when there is sufficient battery power to run the DRP-1. passed onto other externally connected equipment, any channel faders etc. should be down when inserting the headphone jack. Note! Low battery levels will produce no light from the LED, whilst borderline power will produce only a dim output. Due to the widely varying nature of headphones, undesired clipping of the headphone amplifier may occur and will produce harsh distortion.
ENGLISH Some Suggested Set-ups Headphone/ practice amp. Remember that pedal type effects can be added between the guitar and input of the DRP-1 as you would with a normal guitar amp. ● When recording it is recommended that effects are added at the mix stage as is usually the case when recording a standard guitar amp. ● Live sound pre-amp.
GUITAR INPUT JACK INPUT AMP PREAMP VOL. GAIN AMP TONE DRIVER PASSIVE TONE MASTER VOL.
