User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
VS-PTC-IP Manual
www.marshall-usa.com 32
Controlling a Camera
Engaging the Camera OSD Menu for non-IP cameras
1. Press the Menu button on the keyboard to send a command to the camera to engage the OSD menu
2. Navigate the menu by using the joystick
• Move up / down to navigate through menu options
• Move the joystick to the right to send an “enter” command
• Move up / down to adjust values
• Move the joystick to the left to send an “exit” command
Engaging the Camera OSD Menu for PELCO-D or ONVIF-IP Cameras
1. On the alphanumeric keypad, call preset 95 to engage the menu (type 95, and then press the “Call” button)
Manual Movements
• Pan, Tilt, and Zoom movements can be executed simultaneously
• The joystick can be used to pan / tilt the camera in any direction
• The joystick handle can be rotated to zoom in / zoom out
• When not in a menu, the P/T Speed and Zoom Speed dials control how fast the camera Pans, Tilts, and Zooms
in response to commands from the keyboard
• The Zoom Seesaw can be engaged to zoom in / Zoom out