User's Manual

VS-PTC-IP Manual
www.marshall-usa.com 30
Adding VISCA over IP cameras to be controlled via WAN
3. At Camera Location:
• For commands to flow from outside the network into a camera, ports must be opened
• Contact the network administrator at the camera location to create a port-forwarding rule in the router allowing
commands to flow through the necessary ports using these values:
• Source/ external port: 52381
• Destination / internal port: 52381
• IP Address: IP Address of the camera
• Protocol: Both (TCP and UDP)
4. At Keyboard location:
• Set the keyboard to DHCP
• Contact the network administrator at the Keyboard location to create a port-forwarding rule in the router allowing
commands to flow through the necessary ports using these values:
• Source/ external port: 52381
• Destination / internal port: 52381
• IP Address: IP Address of the keyboard
• Protocol: Both (TCP and UDP)
• Within the Setup menu of the VS-PTC-IP, add the VISCA over IP camera using the WAN IP of the camera location
as the IP Address
• Click the P/T Speed dial to save