User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
VS-PTC-IP Manual
www.marshall-usa.com 28
Adding a VISCA over IP camera to Keyboard
Adding manually from Local Area Network (LAN)
Selecting VISCAIP (VISCA over IP) as the protocol and clicking the P/T Speed dial will cause the VISCAIP configuration
menu to appear
• Rotate the P/T Speed dial to move the cursor between the IP address octets. Move the cursor to each octet and
use the alphanumeric keypad to enter its value. Rotate the P/T Speed dial to move to the next octet and repeat
until all IP address octets are set to the desired values.
• Click the Zoom Speed dial to save
• Exit this menu
Repeat this process for each camera that you wish to control with the VS-PTC-IP keyboard.