User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
23
• Expand - Handles camera numbers as binary numbers.
• Tally input numbers 8 and higher in a serial connection are ignored. In this case, the response is equivalent
to no input.
• Numbers in a LAN connection, corresponding to cameras 1 to 10 in groups 1 to 10, are handled as the
numbers 1 to 100. Tally input numbers 101 and higher are ignored. In this case, the response is equivalent to
no input.
Camera Link - Turns tally lamp control on/off. The tally lamp control operation varies depending on the combination
of the SETTING and CAMERA LINK settings. For details, see “Tally lamp control operation” below.
6. Password Setting
• Old Password: Enter the current password
• New Password: Enter the password you would like to set
• Confirm: Enter the new password again to confirm
• Save: Select this to apply the password. “OK” will appear, confirming that the new password has been applied
Model Info
The Model info screen contains the current IP address and Firmware Version of the unit