User's Manual
Table Of Contents
- Notice
- OLE_LINK1
- OLE_LINK2
- Environmental_Protection
- Symbols
- Safety_and_Compliance_Information
- Safety_Information
- Regulatory_Compliance
- FCC_Part_15
- This_device_may_not_cause_harmful_interf
- This_device_must_accept_any_interference
- LVD/EMC_Directive
- WEEE_Directive–2002/96/EC
- _GoBack
- Adjusting_and_Setting_with_Menus
- _bookmark9
- PICTURE_Menu
- _bookmark17
- Adjusting_the_Camera
- _bookmark26
- Appendix
- Troubleshooting
- Menu_Configuration
- License
VS-PTC-IP Manual
www.marshall-usa.com 22
Factory Default
Clear all keyboard settings, and restore factory default
• From the Keyboard Setup Menu, select FACTORY DEFAULT
• Select Yes
NOTE: DO NOT move the Joystick nor the Zooming Seesaw and leave them at original position while the FACTORY
DEFAULT is processing.
GPI I/O
GPI I/O Menu is used to configure the Tally settings
Setting:
• Input - Sets the control signal direction of the GPI I/O connector to INPUT. In this case, connect a tally control
input signal to the connector
• Output - Sets the control signal direction of the GPI I/O connector to OUTPUT. In this case, the connector functions
as a contact output connector which outputs the camera number of the target camera.
Tally Mode
• Normal - Displays the tally input lamp corresponding to the number of the camera with tally input ON, and
automatically selects the camera as the target camera.
• On Air - Displays the tally input lamp corresponding to the number of the camera with tally input ON.
Command Select:
• Standard - Sets the input/output method to STANDARD method. The camera numbers and input/output pin
numbers have a 1:1 correspondence.
• If the unit and cameras are connected by serial connection, cameras 1 to 7 correspond to input/outputs 1 to 7.
• If the unit and cameras are connected by LAN connection, cameras 1 to 10 in group 1 correspond to input/
outputs 1 to 10.